ENVE M7 Bar (25mm rise) Handlebar
What the checker says1will not fit
Run variant by variant through the mountain bike builder’s own engine. Every sentence below is the checker’s, unedited. Nothing here says this part fits your bike; it says what it does and does not fit among the parts we hold.
Checked against 5904 verified mountain bike parts in this catalog. 5770 produced no finding of any kind.
Will not fit
- Will not fiterror · StemBar/stem clamp mismatch: Handlebar is 35mm but Stem is 31.8mm - a bigger bar cannot fit a smaller stem clamp. On 134 of the 252 verified stems in this catalog.
$225.00 MSRP·240 g
What the maker states
- Clamp
- Bar clamp 35 mm
- Width
- 800 mm
- Rise
- 25 mm
- Material
- Carbon construction
Source
Source: the maker’s page. Last checked 2026-07-16.
Checked against
The checker ran this model against every verified part below that it has a slot for, the same way it checks a build in the builder. What follows is the verdict it actually produced for that specific pairing — not a recommendation, and not a guarantee any of these parts fits your own bike.
- 5DEV R-SPEC Trail/Enduro Cranks (Crankset) No conflicts found
- 9point8 Fall Line (Dropper Post) No conflicts found
- 9point8 Stout (31.8, 30mm) (Stem) Will not fit
- ACID SLX 30 front (Front Wheel) No conflicts found
- ACID SLX 30 rear (Rear Wheel) No conflicts found
- Acros ZS44/ZS56 (Headset) No conflicts found
6 of 1747 counterparts with a page of their own that the checker actually probed this model against, in alphabetical order by brand and model — never by price, popularity or the verdict itself.